Square Tube Dies for 200 "Bottle-Jack" Tube and Pipe Bender

These dies fit the 302 "One-Shot" Tube and Pipe Bender for bending square tubing with a maximum degree of bend of 90 degrees after springback.

Pay close attention to the following terms (for more information on these terms, see our "Tube and Pipe Bending Basics" page, located under the Resources tab) : 

OD: Refers to the actual Outside Diameter of the tube as measured with a caliper.
CLR: stands for Center Line Radius, meaning the bend radius as measured from the apex of the bend to the middle of the tubing.
Minimum Wall: This column represents the minimum recommended wall thicknesses for bending mild steel. For any other types of material, call our tech department at +1 (813) 986-9000.
Maximum Wall: The maximum wall thickness that the die is rated for. Bending square tubing with a wall thickness of more than 0.083" requires special dies. Please call our tech department at +1 (813) 986-9000 to order.

Sorry, there are no products in this collection